Sponsors
banner7
Tuesday 21 November, 2017 | RSS Feed

315/433Mhz Remote Control Code Coppier user manuals

by NandRepair.com


315/433Mhz Remote Control Code Scanner can receives the signal sent by the fixed code anti-theft system. Then save and copy the master’s remote control signal. It is special remote controller for car frenquency range 315/433mhz.

How to use 315Mhz/433Mhz remote control code scanner(coppier)? Here Nandrepair  will list instructions of 315Mhz 433Mhz remote control code coppier.

Scan/copy and save receiption

1. Turn on the power. (the screen Display: Remote control Decode the tool)

2. Press any key on the remote control receiver. (Display the remote control password)

3. By the host of the fifth key to save the password, you can save thirty yards, more than thirty; it will automatically

flush the code stored in the beginning.

4. When press the sixth key, there is “*”, that means the device refuse accept the signal. And press the sixth key again,

“*” disappear, and the device can accept the signal again.

Use as a remote control interfere-- transmit power

1. Press The first key and the second key together, display Remote co01001 Decode the too S

2. Then Press the car Remote Control Code Detector key (the fifth key) to call the saved password. What is the sequence you  want to send out decided by the times of you press the fifth button (select the password by press the fifth buton times, if

you want select the first password ,you need press 1 time fifth button,and if you want select second password ,you need press 2 tmes fifth button,etc..)

3. And then press any key(first~fourth) to launches the password you selected.If you want to change the launch password, you can set up it though the first four keys. After finished, you can press the fifth key to launch.

Remote control code Detecting---Detector function:

1. Press the fifth key of the Remote Control Code Detector one time, then the second key of theRemote Control Code coppier one time, finally the fifth key of the host one time. After doing that, it will start to scan. When scanning the password, it will open.

2. The fifth key of the Remote Control Code Detector is pause key. After the pause, you can freely to mobilize vibration

resistance and address code.

3. The code condition it plays it as the following: two state code 0, 1. Three states code 0, 1, 2. Three states code 0, 1,

2, 3. 0, 1, 2, 3 representative for high level L, low level H and empty feet F.

 

 






News for Monday 20 November, 2017


View all news for Monday 20 November, 2017 on one page




Recent News




News archive