Sponsors
banner7
Sunday 18 June, 2017 | RSS Feed

AUTOOL SDT-206 SDT206 Smoke Leak Detector User Manual

by NandRepair.com


AUTOOL SDT-206 Smoke Leak Detector User Manual from nandrepair. SDT206 pipe systems tester fuel pipe, air intake system and cooling tank Detector User guide. How to use AUTOOL SDT-206 Detector, if you bought this item, please read this article as follows:

I.Packing List.

1.Main Unit
2.Hook (with hand-tighten nuts)
3.Smoke output tube
4.Power cable
5.Rubber stopples (with serial specification)
6.Taper stopple
7.Taper pipe
8.30ml oil bottle
9.User manual



II. Main Unit Structure:

SDT-206is designed for detecting the leakage of pipe systems on cars, motorcycles, such as fuel pipe, air intake system and cooling tank.

SDT-206 is for all pipe systems except EVAP.

Hook: To hang the detector when detecting

Power Indicator: To show detector status

Working Indicator: It is lit when the detector works

Power Switch: Power it on, and the detector works

Pressure gauge: To show the pressure when detecting

Flow gauge: To adjust the smoke flow, and judge the leakage severity by flow amount change
Smoke output tube: The smoke outlet which connecting with detection port

Power clip: To connect with vehicle battery. The voltage is DC12V.

Cautions:

1.When you use this detector the first time, please fill 20-30ml oil, not beyond this range.
2.New oil can be filled with only when the smoke is light,and it can’t be filled over 15ml every time.
3.Before filling new oil, please pour out the remaining oil in the detector.

4.Please replace the detector oil regularly.

III. Operation

1. Open the engine cover, and hang the detector in the cover.
2. Disconnect the pipe that needs to be connected with detector. If the pipe needs to be disconnected in the middle. Please secure the other side with a rubber stopple.
3. Secure this side with proper taper stopple/pipe, and connect it with smoke output tube.
4. Connect detector with DC12V battery: red with positive, black with negative. Do not connect in a contrary way.
5. Turn on the power switch, and detector starts to work.
6. Adjust the flow gauge. Control the input smoke value and pressure to make sure the pipe system can afford the pressure.
7. In about 3 minutes, the pipe will be filled with smoke.
8. Observe the floating ball in flow gauge. If the floating ball stays still in the bottom, the pipe is sealed with. If the floating ball is arising or bouncing, the pipe is leaking.
9. Position the leak points by floating ball. If the bounce arises highly, the leakage is serious.
10.Check the leak points. Please use head lamp if necessary.
11.After leak detection, please connect well the wires and pipe.
12.Notes:

Please do leak detection away from smoke-sensitive parts. Not suitable for EVAP.
Do not run the detector over 5 minutes. It needs interval rest.

The detector has protector. If it exceeds working limit, it will power off automatically. In this condition, please operate it later.

IV. Maintenance

With longtime high temperature, the smoke and oil will oxidize and deteriorate. It will infect the service life of smoke generated part, so please change smoke and oil regularly.

1. Before filling new oil, please pour out the remaining oil in the detector.
2. When the smoke output has water drops, please replace with new oil.
3. Liquid paraffin and baby oil are OK.
4. Please fill new oil with equipped oil bottle

V. Product Information

Power: DC12V, vehicle battery

Smoke output value: 6l/min Built-in air supply Controllable flow value






News for Saturday 17 June, 2017


View all news for Saturday 17 June, 2017 on one page




Recent News




News archive