Sponsors
banner7
Wednesday 24 August, 2016 | RSS Feed

El-50448 Tire Pressure Sensor TPMS OEC-T5 User Manual

by NandRepair.com


El-50448 Tire Pressure Monitor Sensor is special for GM Vehicles, El-50448 OEC-T5 equipped with a 315 or 433 MHz Tire Pressure Monitoring system. Do you know how to use El-50448 Tire Pressure sensor?


El-50448 Tire Pressure Monitor Sensor El-50448 TPMS Activation Tool OEC-T5



How to use El-50448 Tire Pressure sensor?

Before tire pressure monitoring system works normally properly, the body control module will record ID information of each position in the tire pressure sensor; and use the following methods to read the tire pressure sensor after replacing a tire or wheel speed sensor. Please refer to the specific methods as follows:

Step 1 - Enter leaning mode

Set the gearshift lever to "P"
Put the ignition switch to “ON”
Enter the interface of tire pressure display by DIC
DIC shows "Press Set / Ctrl to re-learn"
Press “Set / Ctrl”
The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode

Step 2 - Read tire pressure sensor information

Start from the front-left wheel,
Make the J-46079 or Diagnostic Tool EL-50448 antenna up against the valve core position & close to the rim of the tire sidewall
El-50448 tire pressure tool starts by the start switch
Successful to read the tire pressure sensor information when the horn bleeps once

Step 3 - Same method to read other tire pressure information

Follow the instuction above to read tire pussure of the front-right, rear-right, rear-left wheels.
Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete.






News for Tuesday 23 August, 2016


View all news for Tuesday 23 August, 2016 on one page




Recent News




News archive