Sponsors
banner7
Tuesday 06 February, 2018 | RSS Feed

How to Update Fcar FVCI J2534 Passthru Software & Firmware?

by NandRepair.com


FVCI is a PASS-THRU device of FCAR. the FVCI J2534 VCI supports multiply communication manner of DOIP protocol, and it can set up Ethernet(tx_+, tx_-, rx_+, rx_-) and active line to any pin number of OBD2 except for ground pins and power pin. before you get Fcar FVCI Passthru J2534 VCI Diagnosis, you have to know How to Update Fcar FVCI J2534 Passthru Software & Firmware.

Official website: www.fcar.com

1. Click "FVCI" icon on the desktop. Note: The computer must be connected to internet.
2. Click "Read Version" can read FVCI software and hardware version.
3. Click "Firmware Update" can update the hardware.
4. Click "Software Update" can update the software.
5. Click "DOIP", then click "Enter DOIP mode", the FVCI will enter the situation of Ethernet convert to OBD2 of DOIP.
6. Click "Firmware Refresh" when you operate"firmware update" error.

Update Tips:

1)  Please enable internet connection before upgrade
2)  The firmware version and software version must be the newest version meanwhile. Otherwise the device will appear some error.
3)  If you use "Firmware update" failed, you can use "Firmware refresh".






News for Monday 05 February, 2018


View all news for Monday 05 February, 2018 on one page




Recent News




News archive