Sponsors
banner7
Monday 14 November, 2016 | RSS Feed

V4.94 Digiprog3 Mileage Correction Tool Setup Manual

by NandRepair.com


V4.94 Digiprog3 Mileage Correction Tool is the newest version of digiprog3. V4.94 Digiprog3 adds more car models than digiprog V4.88. Here is the instuction of digiprog III odometer master setup.


Digiprog 3 V4.94 Digiprog III DP3 Digi prog3 Odometer Master



V4.94 Digiprog3 Mileage Correction Tool Setup Manual

1. Connect the digiprog3 main unit to the obd diagnostic socket, but don't use the cigar lighter lead. otherwise, it will lost the warranty.
2. After well connection with vihicle, the digiprog3 main unit will power on, and the device is loading the system.
3. Then the device screen will display digiprog III software(free download) version information. software is marked as unique 12 digit electronic serial number.
4. When your digiprog3 has finished loading an information screen will appear with a disclaimer regarding the use of the machine.
5. Click " check/tick" button to start using digiprog3 odometer correction tool.
6. The digiprog3 will require password to enter the system, the default password is "1".
7. Welcome the main interface. you are also allowed to check the software.
8. Select the function you need to do and follow the screen instuction.

Note:

The V4.94 digiprog3 comes with ST01/ST04 cable, so you don't have to buy extra cable is your ST01/ST04 Cable is available...

A regulated 12V power supply should be used to power your digiprog III. if power up by above 13.5V is used to power the machine, damage maybe caused to the main circuit board and it will need to be sent to your digiprog3 dealer for repair.

 






News for Sunday 13 November, 2016


View all news for Sunday 13 November, 2016 on one page




Recent News




News archive