Sponsors
banner7
Tuesday 22 May, 2018 | RSS Feed

WOYO PDR-007 Induction Heater Dents Sheet Metal Repair warnings

by NandRepair.com


paintless dent repair tools is essential for auto body repair technicians, it is important to pick the best paintless dent repair tool for your jobs. you need the right paintless dent removal tools and equipment to complete safe and top quality repairs, WOYO PDR-007 is the one which you are needed, which is 100% original one from China manufactory.

Now we will talk about some of tips before you using the WOYO PDR-007 Induction Heater Dents, in order to Correct use Sheet Metal Repair Tools to  quick fix the problem vehicles, save more time!

Important warnings for use WOYO PDR-007:

1. While the restoration head is restoring a damaged car body, the temperatures of both the restoration head and the body will rapidly increase. Do not touch either the restoration head or the car body before they have had time to cool down.

2. While the restoration head is in the process of restoration, the temperatures of both the restoration head and the damaged area will rapidly increase. Using the restoration head on one area for too long may increase temperatures to the point of damaging the car's paint job (it is
recommended that every 1-1.5 seconds, the operator wipes down the damaged area with a wet rag in order to keep the temperature manageable).

3. During the restoration process, the temperatures of both the restoration head and the damaged area will rapidly increase and the body of the car will immediately become softer. During restoration,make sure the restoration head is not applying pressure to the car, otherwise the restoration process itself might further dent the car.

4. The "Time/effect Dial" intensity can be set between 20% and 100%. This is the strength that the device runs at. Press the "Work" button to activate the device. Let go of it and the device will stop.

5. Connect the "Extension Cable" to the device's Quick Connect head and the Restoration Head's Quick Connection head, and the device is ready to use.

6. After work is complete, set the "Time/effect Dial" to "OFF", and after 5-10 minutes, set the "ON/OFF Switch" to "OFF" as well. Give the device time to cool down, and then remove the "220V Power Cable". Every time you use the device, repeat the steps above for a safe and effective experience.

 






Other news for Tuesday 22 May, 2018


View all news for Tuesday 22 May, 2018 on one page




News for Monday 21 May, 2018


View all news for Monday 21 May, 2018 on one page




Recent News




News archive